Date: 21st – 22nd February 2012
Time: 9.00 am – 5.00 pm
Speaker: IR. GARY LIM ENG HWA
Venue: TUS Lecture Room, 2nd Floor, Wisma IEM, PJ,
LEARNING KEY OUTCOME
At the end of the training course, participants should be able to:
1. Understand the basis to determine the cold water storage demand and size the transfer pump accordingly
2. Select the suitable type of pumping system to meet the water usage requirements namely direct, variable speed drive, pneumatic tank
3. Select the piping material amongst the many choices of plastic and metal
4. Calculate the piping size for cold water in accordance to the BS6700 standard methodology of Loading Units
5. Take preventive measures to minimize the impact of water hammer to the pipe lines by way of design and selection of the right equipment
6. Determine the stack size of Soil, Waste, Vent (SWV) using Discharge Unit methodology and understand the constraints impose on branch discharge pipe in particular on the gradient to minimize blockage
7. Observant of poorly installed plumbing and SWV systems which are preventable
Engr. Ir. Gary Lim Eng Hwa BE(Mech.) NZ, Mgt Dip. FIEM, P.Eng, Asean Eng.
Ir Gary Lim is an experienced and qualified Professional Engineer with over 20 years of manufacturing experience in these areas; Industrial Engineering (Work Study), Project Management, Maintenance, Production and Factory Management. The 20 years of his work spanned over various industries namely industrial chemicals, diary products, jam, sauces, chocolates, confectionnaires, industrial gases (liquid nitrogen, oxygen, argon, etc), blow moulding of plastic containers and paint manufacturing (highly fire hazardous). In the diary industry involved in the design of Clean-In-Place (CIP) system of the process pipings.
If you require further details or clarifications kindly contract the IEM Secretariat at:
The Institution of Engineers, Malaysia
Lot 60/62, Jalan 52/4
46720 Petaling Jaya
Selangor Darul Ehsan
Tel No: 03-7968 4001/02 Fax : 03-7957 7678
Email Address: mizi@iem.org.my
Prepared by Mr. Mizi
Posted by Engr. Mei Wong
No comments:
Post a Comment